Spring Cleaning: How to Clean Your Dryer Vent
Today’s spring cleaning tip is a fairly simple task that will save you money and, in the right circumstances, save your property or your even lives. Last week we cleaned our washing machines and this week we are cleaning the vent on our clothes dryers. As with your washer, keeping this appliance clean will extend the life of the dryer, but also result in Â clothes drying faster, using less energy and costing less money. But did you know that plugged dryer vents are a common cause of household fires? That makes this spring cleaning task a must do! Let’s break it down step-by-step:
- Unplug your dryer from the electricity.
- If your dryer uses gas power, shut off the gas while you perform the task and unplug the gas line from the dryer.
- Pull the dryer out about 1-2 feet, keeping the accordion-type hose still attached at both ends.
- Use a screwdriver to loosen the clamp on the end of the hose that attaches to the dryer. Once loose, pull the dryer completely out so that you can get to all areas.
- Using your hand or a hose vacuum, reach inside the back vent of the dryer and remove lint and debris.
- Using a screwdriver to loosen the clamp, remove the other end of the accordion hose that leads to your exterior vent.
- Examine the accordion hose for tears, then use your hand or the vacuum to clear out the interior of the hose. If there is major buildup or blockage, use a long wooden spoon or dowel to break it up and loosen the debris. Patch any tears or replace hose if it is damaged.
- Using your hand or a hose vacuum, clear out any lint and debris from the portal that leads to the exterior vent.
- Re-connect both ends of the accordion hose to each port and secure the clamps.
- Push the dryer back into place carefully, so as not to crimp or loosen the accordion hose. DO NOT reconnect gas or electricity yet.
- Locate the exterior dryer vent on the outside of your house. Using a screwdriver, remove the external cover and clean it thoroughly.
- Using your hand or a hose vacuum, reach as far inside the vent as possible to clear out lint, debris, or any blockage.
- Re-attach the vent cover.
- To test the air flow, tie a light piece of ribbon or string to the vent cover.
- Plug in electricity and gas.
- Place a load of laundry in the dryer and start it.
- Go back to the exterior vent and make sure the ribbon is blowing, indicating that the airflow is good.
- Remove the ribbon and enjoy a well-working, well-vented dryer!
Helpful hints for dryer use:
- Use only half of a dryer sheet for each load. This will cut down on the “waxy” buildup in your vents.
- Don’t overload your dryer. This can overheat the machinery and also burn clothes.
- Clean dryer vents every six months for best results.
- For safety purposes, never start your dryer before leaving the house.